Over 2020, shipping companies have increased their pricing by roughly 20%, as devastated as we are with this, we must adjust to keep the business alive. Take care when cleaning the surface afterwards, sharp points and corners could get lifted accidentally.ĭue to Covid-19, logistics companies are facing stressed out infrastructure globally, so expect some shipping delays that are out of our control.

Use common sense! Whilst they are rated for outdoor use, don’t place them anywhere there will be extreme temperatures, take care of your girls.ĭon’t put them anywhere normal stickers won't go, that is on surfaces which aren’t flat and smooth.

Drag the knife towards you gently holding the same angle around 30 degrees. Do the side sections separate from the top and trim using a razor blade sitting in the corner the seal makes with the windshield.

Press down firmly with the squeegee to get it up to the seal.

Trim the banner on the top and sides leaving 5mm where the windscreen seals are.

You can continue to push out the water firmly to apply the rest of the area with the backing paper removed.

Tack down the centre by pressing down with your finger before firmly pushing out the water with the Seconds Please! Squeegee in the same area.

Make sure all your adjustments are made at this stage before progressing.

Spray down the windscreen and vinyl with water thoroughly (More cant hurt).

Lift up half the banner on the long side and peel off the backing paper and trim halfway.

Use masking tape to keep the banner centred (Align the banner vertically and horizontally, use a ruler for precise measurements)

Measure out how you want it to fit, we recommend keeping the logo under the top of the windshield at minimum and above the arrows marked on the windscreen (whatever is legal for your country for sunstrips).

Application tape can be removed instantly.

Take your time and line it up, tack from trimmed half of backing paper.

(Clean but hardest method of application) Remove from largest decal area to thinnest, avoid removing directly towards thin areas. Recommended to leave on application tape as the decal adheres for a few hours before removal.Work slowly and remove as much water as possible taking care not to trap any bubbles. “Tack” centre of decal down firmly and hold with one hand, press down firmly using a card or Squeegee at an angle and work from center out in an arc.Make sure to position it how you want at this stage. Remove decal backing paper and apply as gently as possible from center outwards.Spray down surface with as much water as possible.Use isopropyl alcohol, alcohol wipes, or a detergent to remove any dirt and oils. Ensure surface is appropriately cleaned beforehand and weather is calm.(Messy but the safest method of application) General Sticker application rules apply but here’s how you apply them properly!

Hentai stickers whatsapp